Separate names with a comma.
Some features disabled for guests. Register Today.
Firmware bug! Updated Firmware. Control did not like it when I restored my backup config though, it NaN on my network settings and never grabbed...
....no, it must not be. Control v1.0.370, but looking at the picture it shows ver 1.1f.20220325; so I bet it's on an old version. Crossing my...
It's not an Acro, but I did use that as a starting place. Long story short - machine was originally an OxMetal (modified Ox with lead screws),...
[MEDIA]
Reset button does not resolve the problem. I attempted this about 4 times in succession (reset, wait for boot up, button press once loaded and...
Did support help? What was the fix? I have the same problem - I found rebooting just the black-box (vs powering off everything) will bring the...
Speed: X axis topped out at 7,100 mm/min working, anything higher and it loses steps, 20% = ~5,700 Y axis topped out at 5,600 mm/min working,...
Isn't that mains earth? No different than plugging into the ground on my power supply? The ground on my power supply goes to the ground on my...
Are there any limitations using Interface or OBControl? If I jog the machine, will it go to it's max speed? I've noticed that I can get a cut to...
So a jog motion from OBControl of say 400mm, down the X. Any suggestions for safely testing Y? Is this a hope and pray exercise? Hold a...
Would you recommend only testing with the x axis? If it stalls out, you aren't torking the machine. If the y stalls out for one of the motors I...
Does anyone happen to know the max mm/min of the Acro Lead Screw system? My new build is most similar to an acro lead screw - Nema 23 high...
The documentation states: "The shield has to be connected to Earth to channel away any EMI that induces in the shield, thus acting as a barrier...
I will take that IOT off your hands. DM me if it's not sold already.
Will do. I happened to use shielded cable for the limit switches as that was going in originally without the Openbuilds limit switches. Since I...
Nope, did not hit my limit switches. All of which are Openbuilds limit switches. Each one tested out properly before I started the job. I do...
Running a job that required me to change bits, so I had to reset my z axis height but nothing else. X and Y I needed constant and I couldn't...
New discovery as I was setting up my brand new CNC. The Shinwa H101-E, "high precision" ruler, isn't precise. Over 600 mm it's off by ~2 mm. I...
Any idea when that PowerCase will be back in stock. I've been stalking your website hoping for it's return. That and the IOT Relay. I'll...
Just so you know, I watched the install video almost a dozen times. Take a look where they terminate ground to. You and I have been talking...