Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks, Peter. Time to start adjusting and testing.
In Lightburn GRBL 120,121,122 rate is set at 700mm/sec. so I read this correctly I should slow this down until it stops binding! correct!
Only while running job. max feed rate is 150 and it is a GRBL controller. it is moving fast but it will get a quarter of the job done then start...
Oh! it does this using Lightburn laser program
Thanks for the quick responses Alex. I did as you requested and there was no binding moving the gantry with my fingers. It will bind in different...
Sorry for not being very clear. The X gantry stops the motor continues to try and move it.
I have been using my Lead 1010 for quite some time. Now the X feed is hanging up. I have adjusted the wheels several times and it still is hanging...
Thanks Peter I installed and external hard drive. I guess it did not like it. Its back.
was working fine then no controller. screen shot of what i get now. any suggestions[ATTACH]
Will do. Thanks
It will not load on to the CAM program. I try to open file so I can configure toolpath and get the message.
This is the file.
Hello, I,m trying to open an SVG file from Inkscape to the CAM program and I get this error message. [ATTACH] Any suggestions on what I,m doing...
Hello all. My name is Bill. I'm in need of help with my lead 1010 as I can't get it going. I live in N.E. Mesa,AZ. If there is anyone close I...
I removed the new wiring and restarted. I get the same message.
I'll do that.
I have an Lead 1010 with V3 Sparks controller and have been using it for quite some time with no problems. I just purchased a 4.2 Jtech laser and...
Thanks all.
I'm looking at a project that is 2' x 7' and there is a continues cut on the long side. My Lead will not cut that long is there a way to get this...
Got it. Thanks. What a pain in the you know what.