Separate names with a comma.
Some features disabled for guests. Register Today.
Hi Gary I sorted out Cambam got the origin sorted everything working well. Thank you very much for your help it is great to speak to someone who...
Hi, i am using cambam
My Jogging is going to the right direction. I am not sure how to get the G-Code to start point to right.
[ATTACH] Here is my current settings
If I change any setting then Homing and cutting direction is the same. after homing cutting also move towards the switch so it cuts of straight...
Hi Gary Set $23=1 Top left home location.
Hi Gary Hopefully this is the last question, you were great thank you very much for all your help. I attached a picture, when I do homing all...
Hi Gary, I am not sure what you mean by controller but I am using a nema17 stepper motor with aTB6600 driver and universal g-code Platform on...
Hi, Thank you very much this is great. Do you know where do I set the jogging speed, my jogging speed is very slow?
Hi Gary Thank you very much for your help I will give it a go. Can you also hep me to change the direction of my motor when I do homing? Also can...
Hi Gary Thank you very much for your help. I tried everything but still can't disable Homing for Z-Axis I am just going to add a small motor with...
Hi Gary, sorry to bother you again. Can you please help? I use xloader to load the hex file onto my arduino. Can you please tell me which config...
Hi Where is the correct Config.h file I found one but it is in my documents folder. If I update it and upload it with Arduino then by GRBL...
Thanks Gary I will give it a go Thanks for all your help
Hi I tried but not sure what to do, my programming skills isn't that great. Can you please help?
Hi Sonny I am using GRBL 1.1 and I am building a laser cutter. The problem I have is that when running the homing cycle it is try to home the Z...
Hi Gary I figured out what is wrong. Because I am building a laser cutter I do not use Z Axis that is why nothing happens as noting is connected...
Hi Gary My jogging works fine, movements are good. No motor movement when I do $H for homing. When I select verbose output and press the x axis...
Hi Gary I am trying to setup homing but it does not work, when I run $H noting happens motors are not moving. then after a while I get the...
Gary thank you very much for your help. I will try the hard limits, If I can't get it working can I contact you again?
