Separate names with a comma.
Some features disabled for guests. Register Today.
I pulled it to pieces today, testing every element. Turns out the plugable relay module for the coolant/dust extractor circuit was essentially...
Yeah, ‘stray voltage’ was a bit of an understatement ;D good idea about omitting the 24v PSU for troubleshooting. I’ll pick this up tomorrow and...
It’s been reborn!
Peter, An example is when the contractors are energised, 240v ac is present when I test the 24v dc black box psu line to Earth.
Hi all, I have built an electronics enclosure for my CNC router, incorporating a estop circuit and relays for dust extraction and spindle coolant...
Is it just as simple as installing two sets of wires into the connector?
Is it possible to drive two sets of dual motors with the Blackbox? I’m looking at a fixed gantry with 1 motor for Y, 2 motors for Z and 2 motors...
I have been having this same problem with my ProbePlus, and sounds like I have a similar VFD setup. I will try the workaround mentioned, but does...
Any tips for resetting the stepper drivers? Along with the x axis becoming unresponsive, I’ve had the exclamation light come on the black box....
Thanks peter, That saves me chasing a wild goose! I will play around with some options, and report back...
Yeah, that was me :). I was having some issues with it which I think is just the relay problem. I have simplified my setup to troubleshoot it, and...
I double checked the jumper and tried the Tool On button as well as typing commands. The only Toolhead outputs I’m using are the GND & 0-10V. I...
I am having trouble with the on board relay. It is not responding to M3/M5 commands, even though the jumper is set correctly. However, if I set...
Go for it!
Ok, so I finally got imy VFD/Spindle setup sorted. The picture attached says it all I think, but here are some words to go along with it... Some...
thanks Peter, I'll check those points. I must say I am having trouble troubleshooting this as the USB connection to the Blackbox seems to time...
any ideas why the relay isn't working? I am trying to use it as the spindle on/off trigger for my VFD. It just needs to close two wires which I...
I’ll let you know how I get on. Thanks
Excellent! The only other connections I need to resolve are to my VFD. From the Toolhead output, the GRD goes to COM, 0-10v to VL1. I gather DIR...
