Separate names with a comma.
Some features disabled for guests. Register Today.
After some adventures with the local post loosing my package, bit finally received the BlackBox! Assembling was straight forward: easy, quick a...
Can I get some help understanding how to choose a stepper motor for BlackBox (the most powerful that it will reliably drive)? From earlier posts...
Here's an update on the "lag" issue when swapping direction of movement on the X axis (looses about 0.5mm). The issue is not the motor (i've...
@Chillimonster To lower the bed what i did was to swap the two 2040 extrusions of the base (shorter one going under the longer one) so it gave me...
@Ryan Lock I have not had time to try it yet. I am using xPro (v2) with fast decay mode.
@dddman, thanks for the suggestion. I've filed the tip of the grub screw so it's flat, but that did not have any noticeable improvement. I've ran...
I've noticed a peculiar problem with my OX with movement on X axis. When changing direction of movement there's approximately 0.25mm "lag", i.e....
Today i've updated xPro v2 board to Grbl v1.1. Everything went smoothly. I was hoping to get a much improved jogging support, but UGCS 2 is not...
@Ryan Lock, is it possible/safe to upgrade xPro v2 board with Grbl v1.1?
@Alan Foster, can you share some info on the dust shoe you are using? I've built a dust show which mounts to the spindle, but I've realized this...
Final cut was at full depth. Thanks for the tip, I'll try tightening the belts and increasing microsteps.
The source of the "block" problem that i had was dust. There were a few speckles of sawdust stuck to the bottom of the X rail, which i could not...
Yesterday i was running a test cut on plexiglass, and it was going well, until almost at the end of the cut the X axis started to loose steps...
I have a question about wiring. I want to use a CAT5e (or CAT6) cable to connect physical controls and an emergency stop button to xPro. Will this...
I've been trying to find information about "fast decay" and how to enable it on xPro v2. Also found a post that states that xPro v2 automatically...
Hi Justin, Did you manage to fix the problem with false triggers from noise? I'm having the same issue.
Got around to installing a spoil-board and realised i need some drop-in tee nuts and screws, so have to source some more. Perhaps an option can be...
On the third day build is complete. Everything works as it should! The build went smoothly, except for a couple of hick ups on my part: i only...
I've received the package yesterday! (it took a few days to clear customs) I've started assembling the OX the same day, with my son helping me...
Just got an email notification that my order has been shipped! Woohoo! Thanks, @Ryan Lock, for sending it sooner than expected! As for the...
