Separate names with a comma.
Some features disabled for guests. Register Today.
I've searched my PC for the design file I used but can't find it I'm afraid. However it's dead easy to draw up a design and cut it from cast...
Thanks
I have tried connecting to my X-Pro using an XBee plugged into the board. After changing the XBee baud rate to 115200 it works fine up to a...
I was using a gShield but mid-job it stopped working and the PC wouldn't recognise the Arduino serial port. It transpired that the arduino was...
I have a C-Beam machine with Nema 23s and previously used a GRBLShield/Arduino combo but when it recently got fried I replaced it with an X-Pro...
What I use it for is sending $$ to get the current settings that I can then save to a file. I have two CNC machines with different settings but...
Thanks - found it
Ermmm ... that only contains an example plate and the control software
The C-Beam construction video refers to a "Miscellaneous" folder where I will find the side panel specification. Where will I find this folder?...
I am looking to change from GCode Sender to GRBLPanel. this is mainly because I like the way everything is shown on one page. However I don't...
I cut the 'L' off a standard Allen key. It's a lot easier to insert bolts by hand as you can just spin it between your fingers and then use a...
I have just finished building my C-Beam Machine. The quality of the parts and the finished machine are outstanding - thank you. The...
Thanks for all the advice. I realise that many Gcode creators already add in S commands. However the $N0=S1 solution has achieved what I want -...
Thanks, thats helpful. I haven't yet enabled my limit switches so don't use homing but I will in the future.
Thanks for that. I'll investigate
I want to control the spindle on/off via a relay using the spindle enable pin with M3 and M5. (I am not controlling speed using pwm). I...
I am about to build a C-Beam which I intend to use for PCB routing and relatively lightweight plastic cutting. I am really confused by router...
Thanks for the advice - that's really helpful. I am currently using a micro-mill hat I have adapted to CNC but it is too small for my needs. I...
I am looking for a CNC router primarily to isolation-route PCB boards. The C-Beam seems to be about the right size and I wonder if it is...