Separate names with a comma.
Some features disabled for guests. Register Today.
Worked great. One less thing to worry before running a job :thumbsup:
I had to add more lines as below, since it got rid of M5 , M2 and move to (0,0,.8) from GCODE, when I added the footer begin FOOTER "M9" "M5"...
Yes, it takes a few seconds for the dust collector to fully start sucking air. I'll move it before G0. I guess the M9 at the footer loks good too?...
Looks good? +--------------------------------------------------- + Commands output at the start of the file...
THank Thanks. I'll try this.
Sorry. I should've mentioned earlier. I was sending the code from Vectric pro (with Openbuilds post processor profile)
@Peter Van Der Walt This morning I connected a 2nd IOT relay for the dust collector (1st one for Dewalt 611) to the blackbox 'Cool' port. Also...
@Peter Van Der Walt @OpenBuilds Any idea why I am getting this error on INTERFACE. Happened 3 times today that ruined my projects and...
I have 1.24 installed, but not the latest.
@Peter Van Der Walt This is all I've got while trying to connect to INTERFACE remotely within the same WIFI network. What I am doing wrong? The...
I will definitely try this.. Thanks for the instruction.
Thank. Have you or anyone tried 'over the internet' file transfer to INTERFACE so far? @Peter Van Der Walt Is it something we can do? If so,...
I will get a 2nd IOT instead if that's safer to do...Thanks!
@OpenBuilds Can I use same IOT relay for driving both Deawlt 611 router and Bucktool 1HP 6.5 Amp dust collector ? Both connected to each...
@Peter Van Der Walt I had the soft limit enabled. After running the homing sequence the X, Y jog problem is fixed. I guess I will have to do...
@OpenBuilds @Peter Van Der Walt Having this jogging issue with Interface. It doesnt move X+ or Y+ . Only when I jog X- to certain distance, it...
I agree if it takes that much effort, worth spending time on producting something instead. Thanks for the headsup.
Thanks! Is the homing sequence of openbuilds Control going to take care of this sqauring Y axes I am trying to achieve, if I daisy chain these Y...
Can anyone please share an image of how two wires are connected in 1st switch (one incoming from controller and other outgoing to 2nd switch) ? I...