Separate names with a comma.
Some features disabled for guests. Register Today.
Had that exact issue when I first built mine. Had the frame as square as humanly possible, but did not tension evenly. Result was a skewed gantry...
Indeed! Great detective work. I have another printer that is also direct drive that I will add a damper to as well to see if I can notice any...
Primarily flat or smooth rounded surfaces. I first noticed it when printing some very large cylinders and vases to test out the build volume. On...
Since I am having a very similar issue - Used the C-Bot rework direct extruder front/back plates Hatchbox PLA 75% infll, rectilinear .2mm layer...
I would have to say yes. I attribute most of it to the rather soft rubber feet that I put on the printer when I built it. Wasn't sure how much...
My D-Bot is direct drive as well and I do also see this exact pattern in some of my prints at higher speeds. I just assumed it was some sort of...
No problem! It's the simple things that get you. I tend to focus like a laser on a problem, sometimes failing to look at the bigger picture....
I had the same issue when I first built my D-Bot. Same fan duct and bracket. Couldn't figure it out for a couple of days, then I realized that the...
Never tried any sort of dry lubricant. I'd be interested to see how it performs or if it has any advantage over more traditional ones or if there...
I guess there are a lot of ways to mount the thermistor. I ended up mounting mine on the bottom of the aluminum plate, dead center. Used the press...
Very nice! i did something similar, but with my drill press and a dremel. Your cuts are much cleaner looking. Great job!
Very nice! I guess my main interest would revolve around the particular advantages gained by using the Flex3Drive over either a pure direct or...
That is pretty much what I ended up doing as well. I have a small on e on the direct drive carriage and one on the rear right corner. Helps keep...
I finished up my printer about a week ago, though I already have plans for a few more changes, so it may never be "done". I absolutely love it and...
I am using the direct drive that posted here a while back (by, I believe, Carl) and it works fantastically for Ninjaflex and everything else I...
Nice. I likely compounded the issue by squishing the first layer too much. Wasn't pretty!
