Separate names with a comma.
Some features disabled for guests. Register Today.
You'll need lock collars on each end of the screws.
Because I'm in Canada, I use similar stuff from a different name brand. I use a 20g tube of Lepages Super Glue that looks identical to this...
Carpet tape is a bugger to get off your part. Painter's tape comes off easy. I've got a roll of 2-sided woodworking tape from Amazon to try out...
That looks great. I use blue painters tape and crazy glue beneath the part to avoid having to cut tabs. One layer of tape on the bed, one layer on...
I was just using the regular climb cutting path in Fusion 360. No oil, just some air from my compressor to keep the shavings away from the bit....
I've used the same Yonico bit with some success. I have approached my aluminum cutting differently, with a much lower depth of cut (.2mm if I...
There is a setting to reverse the homing directions. GRBL default is Z up, X Right, Y back (or Z max, X max, Y max) . This is different than...
Just a quick note to say thanks for designing and producing these control boxes. After running my modified OX on a TinyG then an Arduino Nano with...
That's a belt-driven Ox build 500x750mm. I wouldn't pay that much for that one, nope. I don't think it's worth half that. He is including the...
Ordered at 1:03 PM PST, shipped at 1:45 PM! Looking forward to getting mine!
Nice build! You'd probably make a few people happy if you shared your mount designs on Thingiverse.
So I got a notice from Github: "v1.0.157 or later will have this fixed!" That confirms I was correct and OB Control was wrong! :)
I haven't even run a job on OB Control yet. :) There's a list of changes I wanted to make to my Ox variant, and setting up the Nano and discrete...
So, the problem is with OpenBuilds Control, not my hardware or my understanding of the masking. Look at the dropdown, note that 3 and 4 should be...
I really appreciate both your help. I hope I'm not sounding snippy when I respond as that's not my intent. My formal post-secondary schooling was...
That IS how I've got it set it up and it works as you note and GRBL intended. Perhaps my explanation above wasn't clear. I have $3=3 so my...
Thanks for the response. The homing issue behaved the same with Openbuilds Control and also UGS. I had been using single homing switches on each...
I just tried something else to try to narrow down the problem. I tried setting $23=0 and the Z homes correctly. Of course X and Y don't work...
Been a super busy week with the kids, finally got a chance to get back in the shop. Jogging works correctly, but the Z homing always goes towards...
I'll post my grbl settings tomorrow when I'm back in the garage for reference, but yes I've used the grbl mask to reverse the X and Y movement...
