Separate names with a comma.
Some features disabled for guests. Register Today.
Sure thing. With original firmware in place, insert a new 100% cartridge. Some have suggested tossing off a small insignificant print to make the...
I learned today that one can re-flash the firmware to factory, swap out a cartridge and then perform a manual purge from the setup menu. Doing so...
I had to perform the firmware update three times on my printer, but the attempts generated an error on the display, so that was obvious. I think...
It's possible that your firmware update didn't work, as my printer had only a 2% cartridge and printed until it ran out of filament but the chip...
The newer cartridges have a small portion of the outer case/cover equipped with a flap, an entry door of sorts. It is located just under the drive...
Does the edit at the first message of this thread mean that I should back-flash my v1.1 machine to v1.0 for best results? I have toolbox 1.0 and...
Only moments ago, my firmware update to v1.1 was completed. I'm not sure what the initial trouble was, but the attempt was rejected numerous...
Probably is good. Is that what happens with an unmodified firmware as well?
Another question about the firmware patch, if I may. If a cartridge is used that has a registered capacity of say, ten percent, I understand...
This thread seems to be a collection of hijacking, and I'm hopeful this question will find the right destination. I've downloaded the toolbox and...
Imagine if there could be a profile for Simplify3D to work with the Cube3 after the cartridge hack is completed! Unfortunately, one aspect that is...
This is really exciting news! I'm not unhappy that this thread was "hijacked" as I doubt anyone would exchange a simple firmware update for a...
I'm new to this thread, having followed a link posted on another forum. As a (too) long time owner of a Cube3, I'm encouraged by what I've read...
