Separate names with a comma.
Some features disabled for guests. Register Today.
the first post was a bit strange that's what lead to confusion I see the issue you have being a lack of clearance on the Z - raise the machine...
Looking at the thread again if its a OX, just change the fixed bed position by changing the front and rear supports to drop the bed down with a...
A moving Z axis imho is more stable and able to with stand more forces when cutting, over a moving spindle - moving the whole X axis up and down...
You cant get it wrong the switches are clearly marked - a soldered connection is more secure and less prone to issues Com - Common NO - Normally...
A axis is a line of movement, The motion of a spindle is not a Axis eg. X Axis = Left to Right Y Axis = Front to back Z Axis = Up and Down...
Anything over stock will need support on the Y axis as the deflection while cutting can cause issues 450x450 table maybe a problem on a 500mm C...
The issue I have with limit switches is I'm getting a lot of noise and false triggers I have just designed and ordered a opto-coupler pcb, based...
did you allow for the tool offset and what type of cam process are you using for the cut? how many passes ?
Z axis - bottom left and top right Y axis - it depends if your running internal or external wheels, if its external you have to get creative
well there all cnc there is the C Beam, OX and workbee that's why I asked As its 1m x 1m I would look at going with individual drivers rather...
what kit ? and what size ?
Do you get the same issues if you use ugs rather than grbl panel ? What psu are you using ? and what's it rated to ? what is the spec on the pump...
What's the spec on the relay your using ? and can that transistor handle switching the coil ? I had a similar issue with a Arduino project it was...
Its good to see youngsters today having hands on practical experience what is a dying art these days - openbuilds is like a Mechano set, it comes...
This can happen with a change in suppliers, or a spec change, tbh if you got them from ooznest or the opensbuilds shop they usually sort out any...
Its not a issue as its only the control side, power the motors up with the lead screw couplings undone, so the motors can sync with no load -...
only if we had machines that could make them o_O, been there and done that during this rebuild, though I know I can mill that....... oh wait :mad:
The 2 post mount is good for 450 in oz, if you go the with a 4 post mount your going to restrict movement and/or your going to have to raise the...
What drivers/board are you running ? What steppers ? what PSU ? double check that you have wired the steppers correctly ?, I have 2 stepper motors...
The last few days I have been working on the controls 250x250mm 3mm plate to mount the psu and drivers, abs 3d printer backplate, Lumberg 4 pin...