Separate names with a comma.
Some features disabled for guests. Register Today.
Very careful measurements with a square. It actually wasn't too hard, just requires a little patience and a few test prints. You can measure...
Click here for Fusion 360 Interactive Model Summary This printer is a design that has evolved over three years. The original goals of this...
It is fairly heavy, due to the mass of the dual extruders and motors. I am running my z motors wired in series to compensate. This eliminated a...
The banding was due to some earlier designs of this printer used a hanging z lead screw. Once I flipped it and secured the top with thrust bearing...
The single 20x20 offset to the rear allows you to slide the t-nuts down the frame for the Z motor bracket and the lead screw supports. This makes...
I have a question; I submitted a build, but I noticed the time moves forward every time I make a modification. Will it still qualify if I add...
I am still uploading my drawings and parts. Fusion 360 is giving my some headaches sharing the project files. I will upload STLs once I have them...
BinaryConstruct published a new build: This printer is a design that has evolved over three years. The original goals of this project were to...
OpenBuilder Board
Does this board support the probing feature of GRBL 0.9?
I'm running the latest version of GRBL from the source on the edge branch. https://github.com/grbl/grbl/tree/edge I've attached a compiled version...
A while back someone asked how I was doing my max Z endstop, so I figured I would post it. Note: The camera lens makes it looks tilted, but...
I went with the hose clamp version, but a quick search resulted in these: https://www.inventables.com/technologies/bosch-colt-spindle-mount "It...
I just finished getting my first aluminum piece cut and I thought I would share some of my equipment and settings, trial and many errors later....
I didn't add a max, I just set up a min to keep it from going through the spoiler table. There isn't really a good location for a max I have...
I did the same and made a case suited to the 20x40 Vslot on the back of the gantry. [ATTACH] [ATTACH]
I'm using these http://www.kelinginc.net/KL23H51-24-8B.pdf 156 oz-in motors, wired bipolar series, so 3.6 ohms/phase. My motor power supply is...
I am using the grblShield v5 with an Arduino Uno. I have a few RepRaps, so I started with a Sanguinololu but I switched to the grblShield....
What did you use for the fill material? It is defiantly a nice (and functional) touch. Finally got end stops and motion test/calibration. Next is...
Hey everyone, just wanted to say thanks for the designs and a quick plug to Chris and Bill (http://www.opensourceluthiersupply.com/) for their...