Separate names with a comma.
Some features disabled for guests. Register Today.
Figured. Wonder if I could write a macro to do ii in Excel, at least to just re-write the header up til the F-rate command.
@Peter Van Der Walt can you shed some light on why this doesn’t seem to work? Are my GCODE files too long? Still doing this by hand and it’s tedious…
I’m wondering if it’s possible in GRBL to tune motors to the same level that a ShopBots motors can be tuned with respect to ramping during 3D...
Hose Ground: Yes - 18ga copper wire running through the actual dust hose out to a foundation bolt in shop floor. Motors are Open Builds Motors....
@David the swarfer thanks for the suggestions. And yes Peter, my new HY VFD is wired per the specs on Josh's writeup page. I have gone through...
I figured…you have never been anything but more than helpful. Time to build a faraday cage around it I guess. I’ve got some experience being in...
Are the other thousands of users running 100-500MB toolpaths for 16-36 hours that CONTROL can't load into it's editor or preview in 3D? My...
Yesterday in the 12th hour of a 16 hour 3-D finish carving, Control for some reason lost its XY position mid-cut and ruined the last part of the...
This wizard doesn’t seem to work. Is it because my G code is too large and it can’t be loaded into the editor?[ATTACH][ATTACH]
@Peter Van Der Walt Cheers for all the help - so far so good with the new VFD!
I’ve been using Interface…better dig out my laptop!!
Has this been implemented?[ATTACH]
So Peter what was up with the ring of wires/iron ring coil on my old setup? Was that meant to be an EFI filter? Why don’t the new VFDs spec this...
For sure. I am coming from the ShopBot world, when I pause their machines, the code stops, the bit lifts 1" off from the workpiece and the Spindle...
So to make sure I understand you correctly - you would wire a switch into the mains 110V that feed the VFD?
This is a big factor for me because when I pause a 13 hour 3-D finishing cut, I need to be able to turn the spindle off overnight and restart in...
Peter – if I wanted to put in a safety switch to be able to turn the spindle off manually, would I wire the switch into the 0 to 10 V wire coming...
There is continuity between pin #4 on my Spindle and the outer case of the spindle housing. I don’t like the fact that the Huanyang spindle...
Also I have another follow up question: my old VFD came with this card instructing the installing engineer to loop the three UVM cables from the...
Josh how come you specify PD144 = 3,000? Shouldn’t that be 24,000 (Pd144 in the Huanyang manual is “Rated Motor Revolution”. Edit: also, and...
