Separate names with a comma.
Some features disabled for guests. Register Today.
To put this to a close.... I ran a job today that took maybe an hour and used a large portion of my machine bed... It went perfectly so I do...
Back up... and made a few passes back and forth and this is the first time I can go more than twice so this may be fixed..... Again power is out...
Oh and Peter, although it is not dust on where wheels ride, you mentioning that is good... I actually have duct tape on that side holding my wires...
OK fellas.... I "THINK" I may have it..... And now after seeing it, if it is this, it's easy.... I pulled the right lead screw... There was just...
OK... Is not the wires or steppers.... I finally pulled both steppers off back and they run perfectly, no hangups or glitches...However if I turn...
Just going to pull wire and replace... I have no doubt you are correct.... What kills me is to me it looks like those wires NEVER move... So in my...
Well guys, Our power is out from a storm, so I am moving a bit slow here... Generator running... I did check the wire connections from stepper to...
Will double check that tomorrow. I did some searching as I was posting and saw that mentioned..... I'll do a visual, then I also saw a link to how...
That is super helpful
So I've had my machine for a year now, and after some time away from it, I recently got back to it and am using it quite a bit more... With that I...
Oh we had interference.... Like wires rubbed bare...... Well you could say it was interference.....The wire for my Y limit was rubbed raw from...
So I am finally surfacing my spoil board... And I make two very shallow passes, no issue... I run for the third and final time and I get: Alarm...
Thank you Peter....Tried method 2 and it quit out at like 10%...Will try a few more times.... Aslo got probe working with usb drive in interface.....
Was using my 1515 w blackbox after not for quite a while... Did a few carves and everything seemed ok.. On my third carve I tried to use the probe...
Looking to lengthen my wiring so I can move the blackbox. What guage wire should I use? I thought it was 4x22awg, but not totally sure, that just...
Thank you Peter. Just knowing that the software is not clickable is helpful. Will check wiring again as it is very very intermittent. Works most...
Hello, I am having an intermittent issue on my 1515. I am just getting it up and running and my limit switches seem to be working, then sometimes...