Separate names with a comma.
Some features disabled for guests. Register Today.
Finished the holder. [ATTACH] [ATTACH] [ATTACH]
Added a couple of pictures, including updating the main picture to show the spoilboard. I also got a couple of extra C-Beam end plates and put...
I have somewhat limited space to place my router, so I decided to modify the LEAD 1010 to have a LEAD 710 instead. The X Axis C-beam has been...
Just a follow up. The PDs I set were 1,2,3,4,5,8,9,10,11,14,15,70,72,73,141,142,143,144, and they all seemed to update with no issues and my DCM...
Thank you for the PDF. It is the same model as I have, and it is nice to have an electronic copy in case I lose the paper copy. However looking...
Nice plate! Was it easy to tram?
Point well taken. This system though will likely be exclusively wood/plastic. I currently have no plans for metal, as I have an old Index...
Just a quick question here. I'm planning on making a pocket board for my ER collets. I'm limited on horizontal spaces and was thinking it would...
Interesting. I've got a Huanyang 220V, 1.5KW VFD, and I had the FOR and DCM jumpered, and I checked most of the parameters after I programmed...
Are you making sure to do a factory reset of parameters to start? PD013, setting it to 8 is how you do that. Page 28 on the manual linked. If...
Dewalt brushes should be changed every 100 hours runtime according to the owner's manual. However on my first DWP 611, the brushes wore out...
I got a Harbor Freight dust collector for about $170. 4" hose. It take up about 7' of vertical space and the base is about 2' x 3'. (Just...
It's Alive! Cut holes that were round and exactly on size. Downside is I wrote the program when I had to comp for spindle runout, so I'll need...
Added 2 more pictures. One is of the Y drag chain at home position with 4 more links added in. The other is the machine after I've done the...
Added picture of my VFD wiring and 2 of the lid to my water cooling reservoir lid made from a Home Depot bucket. Currently running an hour leak...
Thanks! I've been planning on putting down 20x80 v-slot sections for my table and mounting spoilboards to that when needed and use the table for...
Currently I've got power wired to the VFD, and the shielded motor wires wired into the plug for the spindle. I've got to wait until Friday for...
Torin3 published a new build: Overview of a 700mm x 1000mm machine based on the LEAD design and with the High Z mod from the start. Will have a...
Just a thought here, but the Y axis drag chain is looking a little tight at the end of the homing sequence. I have about 15 links left over from...
Well, just need to get the spindle working and I should be good to go. Adjusted the max travel for the smaller X and larger Z ranges. It will...