Separate names with a comma.
Some features disabled for guests. Register Today.
I am in the middle of internet outage due to my ISP. I seem to be unable to use my INTERFACE controller because I don't have access to the...
I extended the ground wire and wrapped it round the body of the router and that worked.
@Peter Van Der Walt, I have grounded my dust collection to earth ground. I errand the cable for the Interface so it lay on no other electronics....
Read about those earlier .... I don't have any spares laying around .... let me see if I can cook up s some DIY ferrite..
Okay. I will run the test air cut as well. Could the cable between the interface and Blackbox need some form of shielding or grounding?
@Peter Van Der Walt Thank you for the videos. I took the time to run a piece of bare wire down the inside of my 2.5" dust hose and ground it at...
@Peter Van Der Walt Thank you! I figured it out... EMI is my issue via my dust collection hose. I need to get anti-static hose or figure out...
Thank you. Let me read and educate myself so I can get you what you are asking for. I think I know what the issue is .... I am going to give it...
I've not seen this error when using my laptop and I have run successful jobs with the interface. All of the sudden last night I got the error in...
Okay I just checked my Vectric software and I remember I set the post processor the when I purchased the software. Should I now understand...
I have not read through this. I will read through it so I can better understand. I guess I am confused because when I use Openbuilds Control I...
I use VCarve Pro and I am still shy of the information that I am trying to understand. Does the Interface tool turn the router/spindle on and off...
I just got my Interface device and I realize that I have to adjust my G-code to add the Router Start and Router Stop. Below is the comment made...
@Peter Van Der Walt Thank you for taking time to help me yesterday. My blue wire had bad contact and the probe is the most beautiful tool ever!
@Peter Van Der Walt, Awesome & Thank you sir! I will do this and report back. --Leon
@Peter Van Der Walt Thank you for your knowledge and helping out here. Based on your answers I must say your knowledge in this space is super...
Nik, Did you ever get this figured out? I can't seem to get a positive response at all. I get lights but that is about it.