Separate names with a comma.
Some features disabled for guests. Register Today.
Gotcha. Thanks for the suggestion. It sounds like I need to entertain a motion controller overhaul. I was hoping to avoid this, but maybe Ill keep...
I do not see anything in the x32 that is no also available on the x4 version. I get that it is 32 bit. I also know the Micro controller should...
Are you suggesting I replace my Blackbox x4 with a Blackbox x32 or alternative 32 bit controller as the answer in this case? I know 8-bit...
Hi everyone, I am feeling motivated lately and really want to work on some automating some things to make my life a bit easier on my cnc. It’s...
I appreciate the information on the endstops. That is likely a contributing factor and I’ll need to order some NPN ones, it’s very helpful....
I do have PNP normally closed indicatives as those are usually the safe bet. (From what I have read), after frying my board someone mentioned that...
PROBLEM: Well, guys against the advice of my manual, I touched v+ to ground accidentally while troubleshooting setting up my inductive limit...
I supposed piping the script is fair to reduce support but allow people to use Pi’s. They probably don’t understand the implications of half the...
I should clarify, not just curious about people running the Pi. The Ubuntu OS and Pi combination is what I was most curious about. I was unable to...
I am just going to start off by saying I am well aware that the raspberry pi is not 'Not Supported'. I am curious as to which aspect of the...
Power off should be obvious, I wouldnt square a machine with it on unless I had 2 endstops to do it for me.
Please do. I would be interested to know how much voltage\Amps are generated. I move mine less than an inch in most cases. Ill just undo my...
LOL, then the sub-1 inch I move the axis by hand(wheel) if we have a TVS circuit. Gotta tune the machine without unplugging the motors everytime. :p
@Peter Van Der Walt Continuing the conversation off my handwheel project, can you pass this along to the team that will be working on the blackbox...
Yes you are correct. These were designed for correcting out of squareness that happens over time. Since the Y motors are linked in software, this...
This actually isn’t specifically for tensioning, this is used on top of the tension nut after tensioning specifically for manually jogging the...
I guess I forgot to put “Black Box Controller” as what I am using.
I am curious to know if switching the limit switch voltage to 24v using the jumper on the board with negatively impact the probe output. I have...
I made some similar plates for my LEAD I am working on. I like the idea knowing that the beams are fully supported. I never liked the angle plate...