Separate names with a comma.
Some features disabled for guests. Register Today.
Hi there, I’m having an issue where in my y-axis leadscrews don't travel the same distance. The discrepancy is only about 2-3mm between the 2...
Hi there, My machine seems to travel less on one of the Y-axes than the other. I start the gantry at the back of the frame (flush) and by the...
@Giarc that was it! I had a grub screw that wasn't binding the lead screw properly. Popped down to the hardware, replaced it and 5000mm/min seems...
Hey Peter! So here's what I've found. I retried the enabling steps for soft limits as indicated on CONTROL, which seemed to help! I still kept...
Correct, I am using CONTROL. I'll detail the errors and share it in here in the morning. I've powered off the machine for the night on account of...
Hi Peter, It's indicated on the DRO. I didn't know that soft limits alarms were pre-emptively raised based on the upcoming command. Will...
Hi there, I'm trying to set up my soft limits. As an example, I'm trying to set my Z-axis max travel soft limit to 80mm. But after setting it,...
Hey guys, thanks for getting back to me. Sorry for the delay in my response, I only get to work on this over the weekends. @Alex Chambers I gave...
If someone could please help me troubleshoot this that would be greatly appreciated!
Hi there, I've been stuck with this issue for the last 2 weeks and for the life of me can't seem to figure it out. The y-axis is acting up. It...
Hi @Paulie Tweddell, running into the same problem at the moment. Did you find that the suggestions above sorted your issues out?
Hi there, I've got a 1515 machine too. I'm also a total noob to this and I'm sure I'll get the hang of it in time. Just wondering if the only...