Separate names with a comma.
Some features disabled for guests. Register Today.
Sam gave a list of parts( if your talking about the cnc router) on page 1 of this thread.
Very good question Sam. I’ll have to take it apart and make sure I didn’t leave those out when we changed z height. Thanks
Z noise viedo
Just a correction before someone thinks we have totally lost it. Nicks statement "While making these changes, I increased the z axis amount of...
[ATTACH]Cut out as a pocket 1/4 deep then painted
I’m an idiot. I still had the tx rx pins connected to the mega… it wouldn’t allow serial communication with control! So now I have calibrated...
it is not lit up or selectable. $H did not work either.
I will look in to it. In the mean time I am connected to it now, and have CONTROL. Pulled up and connected to the arduino. It says it’s connected,...
Ah. Your ideas are better and better! I do have compressed air and could do this very interesting. But I assume the m8/m9 commands just send a...
I apologize I didn’t notice… I’m a bit slow! Ok, now I love the idea of doing this (using tablet with CONTROL) instead of what I am doing...
I don’t think I have been very clear with what my issue is. I am going to try to explain better. I have now successfully edited the config file...
This is probably the problem…. When I downloaded the grbl master file, I downloaded it to the desktop. When I made the change to the config file I...
Thanks for the info Sam. You must have known I was about to ask.. 8) So the racks that you ordered; were they the 1/2" , 3/4 or 1" face...
Sam, Im glad to see your back at it. Helps motivate us. Did you do rack and pinion for Z axis too? And I assume you used same stepper motors...
But if I am not trying to make extremely precise boards, I could use fusion to design and CONTROL to make circuit boards? Thanks!
I am a little confused. If I wanted to use the auto leveling feature, would I have to do away with the blackbox? Or, can I use the correct host...
Reviving this a little. I watched the John Lauer's tutorials. Really neat. What Are the additional hardware requirements (I use blackbox) to be...
The title pretty much sums up what I'm interested in. I recently saw a video of someone routing circuit boards with a cnc. Does any one have any...
I just ran a different design through. It appeared to be cutting correctly it was dropping about .06 with each pass and the next thing I know the...
Thanks Peter, I did have the fault indicator light on. I reduced the z adjustment screw to keep it from over heating. It has not given me the...