Separate names with a comma.
Some features disabled for guests. Register Today.
These settings are for the VFD itself, nothing to do with a specific controller? I'm switching from Blackbox to AXBB-E. Hoping I'll just need to...
Thanks, Peter. Does anyone in the community repair them?
I did follow the steps in the link. One question regarding that. It says disconnect 'everything' except the USB. Doing this doesn't power the BB....
Three years and not a single problem. Tried to connect today and I'm getting the errors in attachment. I unplugged everything from blackbox to...
I had it right to begin with. Clockwise looking down the barrel, not head on. Been a while since I've fired up the cnc, I sure do miss it. Thanks...
Any reason this would remove torque? It's spinning clockwise now but bogs down and blows breaker. Same feeds and speeds I've always used.
this resolved it, thank you, Peter.
Any of these reverse the rotation? I'm running counter clockwise and I want conventional. Maybe this? P00.16 = 1 ; 1= REV(X6) Determine...
Thank you!
Yes, Openbuilds post. The Z is good at -10, it's the X,Y. I don't want the machine traveling all the way back to -10,-10. Just raise the Z -10 and...
How can I make the tool just rise above where it ends instead of -10 for all? Not sure what post processor I'm using, probably the latest. Looks...
Thanks for the replies. I actually just resolved this by switching two spindle wires. I thought it didn’t matter as long as it went clockwise but...
Spindle is bogging down when doing same toolpath as Router11. It's a simple facing operation I've done a hundred times and the spindle bogs down...
If setting PD011 to a value other than 0, how can you command spindle to turn off?
I changed it and it's working correctly, however it won't turn off with M5. Is this the jumper in the BB that I need to change? Also, will I...
I've got this exact spindle and followed the instructions precisely. I'm not seeing what to set the minimum frequency/RPM to. It looks like 'PD011...
I can send m3s6000 and it'll display that rpm on the VFD as well but I'm not sure what the minimum rpm is for my spindle. I can set it to 1000rpm...
Looks like it can be changed around line 290 in the script?
I've been using Blackbox with Fusion 360 post processor (Swarfer?) successfully for about 2 years. I recently switched to a spindle and when...
Does anyone have their chiller split between laser cutter and water cooled spindle? I think it produces enough flow to move between them, which is...
