Separate names with a comma.
Some features disabled for guests. Register Today.
Are there any plans to implement a bit setter routine in Control, rather than having to do a Z probe each tool change?
Is there a way to make the simulator screen full screen, rather then just the bottom third of the screen?
Thanks Peter I'll give it a try.
I have a large Vcarve file, over 13mb, that fails to load. I remember reading in another post here that there was a switch under the Wizards and...
David, thanks for your insight, gives me something to think about. Gary
I should have stated up front I'm working in inches. Gary
Thanks for the consideration, I'm not sure what Gcode would set the x,y,z increment to .001. I'll have to research that.
I really like your defined increments, .01, .1, 1 etc, but is there a chance you could add an increment of .001. These are very convenient but I...