Separate names with a comma.
Some features disabled for guests. Register Today.
Peter, you are the best.... it was a green loose wire on the back of the blackbox for the y motor. thanks Mike
Peter, I isolated the issue to one Nema 23 motors. I separated both motors from the lead screw and noticed one motor hesitating. THANK YOU so much...
Peter, THANK YOU for the quick response. I sprayed PTFE on the lad screw and I checked all wiring and re-tightned but did not help. I did notice a...
Hi, I have a Openbuilds 1050 been working great for a few years now. But now the left side of my Y is not moving the same pace (dragging) as my...
When you say "if homing is setup correctly".....My issue is within Fusion, before I even connect any cables to the CNC. I design a new project set...
My problem was in Fusion when I Post Process under properties it says "End of Job position" -10 for each XY and Z. So that gets written in the...
Sorry, but I have still not figured out why Fusion still ignores and still has the -10. I still manually set it to 0. I moved on to use Lightburn...
Peter, thank you very much for all your support. Mike
Peter, thank you. One last question. The video is not clear on where these jumpers are because I have the 2790 but the Blackbox in the video looks...
I Have a Workbee 1050 with a 2790 blackbox. I just bought a JTech 7W Laser. A few questions: I read that I need to remove the Relay jumper in...
Peter and rscamp, I want to THANK YOU both for all your help. It was a loose connection with my stepper motor on one side of my Y. I think I am OK...
I did the attached Os to check how clean it could do circles but it still looks like scribbles. I also attached the Fusion file that I inserted...
Rscamp, THANK YOU so much for the valuable info.
Rscamp, thanks for the info. I will try it. I thought my -1.5mm was the depth of my cut. Is there a chance of sharing your fusion file?
Shawn, I think I just found the problem. my Y is not moving as free as it should and I think I need to figure out why my wheels are so hard to...
Shawn, thanks for replying. Attached is the wood carving which I think looked like scribbles. Not sure which preferences I should post. Openbuilds...
I am new to the CNC world. I built the 1050 and use Fusion 360 but my output is not what I thought. Either its my build or the options in Fusion...
I have a Workbee 1050 and use Fusion 360 with post processor of Openbuilds CNC: GRBL/Blackbox. Everytime I start a project in Fusio I have to go...
Thank you all for your comments. I will replace it. Mike
Could anyone look at these side by side couplings and tell me if the right one is ok. The left is a pic of my X which looks fine, I think. The one...