Separate names with a comma.
Some features disabled for guests. Register Today.
I have Plasma Gys CUT 45 CT and the + - is for THC. You can put volmeter on the two wire en mesure voltage when plasma is cutting. If you have...
Sorry Fusion 360 with your Post process
I make my own plasma with CNC workbee 1010 and Blackbox I put Relay jumper to M8/M9 and i use it to put on my plasma I try to cut a rectangle...
Hello, i try to make my thc and i have problem with Settings views. I have to click more than 10 on button to change val (exemple min or max...
Hi, i have 2 questions : my plasma gys cut 45 ct give maximum 20Vdc in 20:1 so if I put 50:1 the analog input could be more than 5v (6,5 v) so...
I try to buy plasma cut 50L but seller can’t deliver to France and I don’t found other website. Some people recommend en other one at the same...
Lasts questions I would like that my cnc do plasma and spindle. Is it possible if I modify post processor fusion 360 that I use m8/m9 command to...
Thank you I am looking for this but not with EU plug. There is change log version of blackbox hardware somewhere ? Thank you for all your answer....
I have power on all except probing. Blowback is so expensive. Do you know some people who work fine with hf start or do you think is possible
When I read forum some people have problem with hard limit switch when we use plasma. I use xtension limit switch and for the floating z I use...
Nothing, all work fine since 1 year. i make ticket
Hello, Since today, i have permanent 24V in the output 0-10V on blackbox !!! What can do this problem ? thank you
I use fusion 360 with plasma postprocessor that you gave me before. I use x tension limit switch but i have this problem. I will try to put more...
hello, i'm here again for plasma problem. So when the command m3 S24000 is sent, the blackbox make an error travel job exceed. So i unplugged the...
Thank you for your answer so i have to connect z floating limitswitch to probe input ?
Hello i have blackbox with spindle and all work fine :) ! I would like to connect plasma cutter when i need. i don’t know if i have to change...
Yes i made a mistake with Chanel and start thread :) thank you very much :)
Peter i read in datasheet than there is 4 chanels but i think like you there is only one ( chanel is how many enter you have in screw for one...
how you found 1600 ? normally it's 200 4 circuits x 2mm = 8 mm pitch so 200*8/8 = 200 step/mm I think sfu is 4circuits x 4mm 16mm pitch so...
Hello, I have blackbox and i install sfu 1204 on my workbee 1010 I don't know what is the new settings for my firmware So I dont understand what...