Separate names with a comma.
Some features disabled for guests. Register Today.
My grbl got uploaded successfully. And yes I mean stepper moters.
Can any one help me in this?? Just wanted to test, whether my servo is working or not?
@Peter Van Der Walt , As suggested from you, I have checked config file and found that "corexy" is already commented. Can you suggest any other...
"low memory...", is due to GRBL being at the limit of what the Atmel chip can handle. But does this affect other execution on board or due to...
While uploading GRBL on arduino uno I am getting below message "Low memory available, stability problems may occur." But uploading also done on...
@phil from seattle, I have install GRBL on arduino uno, also use UGS and try to send some command to the board but getting error. I am attaching...
Also, how did you get GRBL on your arduino? I am not getting your question. Also can you help me in the wiring of my motor with my board. cos I...
@phil from seattle -> do you have power for steppers? have you wired the 4 wires of the stepper motors to the stepper controller outputs (A+,A-,...
@Giarc, Yes I am using GRBL CNC shield on arduino uno and trying to control my motors through serial monitor. I try to use 'G0X10Y0Z0' code on...
I have already mentioned, I have connected my stepper motor to grbl board and I am using KTC CMS Labs A4988 stepper motor. Currently I dont know...
Hey there need help. I am using grbl which is connected to arduino uno, I am trying yo connect my stepper motor to the x axis of grbl and pass...