Separate names with a comma.
Some features disabled for guests. Register Today.
OK. Thanks for your consideration. You've always been willing to listen and help. I appreciate it.
My issue is my probe wiring runs through the wire channels and has a small jack that is mounted to my router mount. I plug my wire from my probe...
I would like to request a new function when running Probe Wizard. When you select Probe from the menu, the next screen gives you 2 buttons,...
I know this is an old thread but I have a similar question as the original post. I tried the sliders and nothing happened. By reading your...
OK that makes sense. Actually my spoil board is screwed to wood supports between the aluminum supports and those wood supports are screwed to the...
Yes, I was figuring on that also. I can move my 1510 closer to one side and extend the other side about 12-15" to accommodate the extra width. I...
Thinking of expanding my screw driven 1510 WorkBee to 1515. I think all I need is the longer 2040 X rails on front and back and 1 for behind the...
I thought my settings were saved in the older version? If so, why the change?
I use a Z probe from my X-Carve that is 15mm thick. The default setting is an Openbuilds probe that is 20mm thick. When I change the value to...
OK Thanks. I knew that but assumed that when I re-installed it that it sent default settings. What happened was, when I opened CONTROL, it said...
My viewer works after I upgraded. The only issue was the upgrade failed so I installed from scratch. Had to reset some GRBL and re-calibrate. I...
Maybe we can request it in a future build?
Is there anywhere on the screen telling you the name of the GCode file that is loaded? Sometimes I have multiple versions of the same GCode and it...
As an update from my testing. If I set my start point as the center of the board and use the Grbl (mm) PP, it works fine. It outlines my carving...
I agree it was a mistake on my part and Thanks again for helping me. I played with selecting the different machines and watched the numbers...
My machine is 1500 x 1000, all axis are screw drive. I picked Workbee 1510 from the drop down because it matched my size. I didn't buy the machine...
Thanks for all your help. That fixed it. Maybe in a future version of the CONTROL software, when you pick the machine there could be another...
Thanks. Suggested values?
I am new to WorkBee so please be kind. I just finished building my WorkBee and am using a BlackBox controller. I am running OpenBuilds CONTROL...
Forgot to mention. I created the file in Aspire using the Grbl (inch) PP. Note: I created GCODE in OpenBuilds CAM and it is acting correctly. Is...