Separate names with a comma.
Some features disabled for guests. Register Today.
There was a small amount of play on the right side of the Y axis, took it out with the collar nearest the motor. Ran it again and it's mostly...
Fairly positive, wasn't trying to break the 1/8" endmill. I could retry with a 1/4" and feel better about using more pressure. Couplers and stop...
This morning I was running back over what motions are happening and possible errors within the CNC machine. If the Y axis motors had a different...
I can get it to move by 0.008 in parallel with the waste board, measured by dial calipers. I really need a dial indicator to get better results,...
I think your money is in the right place, but I'm having trouble finding it. Is there a good source somewhere to follow for troubleshooting? I...
No, just used the circle as a reference. I do have the option to ramp, so I will give that a try. I will also try using Openbuilds software to...
This was a 1/8" downcut bit, I was running it at 0.08" and 25 in/min (plunge) to be conservative while I learn. 55 in/min feed rate.
Measured two points of the circle, 90 degrees apart and away from the lump, the circle appears to be a consistent circle. [ATTACH]
I can't seem to search and find a definitive answer on what is happening. I would say I'm circle trouble shooting, but that's not the correct term...
Sorry for the late response, but here is the mod I just completed. I needed the extra room to engrave the bottom of wood bowls. High Z Mod for...
I bought a used Lead 1010 late last year and have just now dove into working with it heavily. Especially because of the corona virus situation and...
I came here to find this answer as well.