Separate names with a comma.
Some features disabled for guests. Register Today.
FYI.....shutting off the machine and starting all over seemed to do the trick
I got it..... did search on it and found it. Thanks
OK
I did go into the editor and remove G53 lines
I tried that once and it just did the same. So maybe shut the machine off and back on, reset 0 axis?
So again back to the big question...... why was the code running good last night and running poorly this morning. I am stuck. [ATTACH]
OK sorry, I misunderstood what you were saying
Thanks for the help on that. So setting the machine coordinates is done how again?
No limit switches. Could this be one of the issues? I forgot to turn the machine off last night. It was on all night. I do set 0 axis every time....
Peter did you look at my setting for the controller? are they correct? I use open builds post processor and it spits out Gcode that has worked in...
[ATTACH] I stopped the project before it got any further
Thanks anyways:)
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
@Alex Chambers did you say that you use Mach 3 as your controller? Will that work with my grbl board? I at my wits end. This works great when its...
So I just tried another Gcode from the trace and got the same results.
Arrgh! @Alex Chambers , @sharmstr, and @Peter Van Der Walt ..... It has happened again! I shut down the computer over night and opened up the...
I still can't figure out why the 2nd-last pass do not follow exactly the tool path. If you look at the one photo quite a few replies ago it...
Yahoo! So I went and made sure my power cord was out of the way. Not sure if that had anything to do with it, but I was taking screenshots of my...
Ah....OK, I will look at this.
DRO & EMI don't mean anything to me yet. how do I check for these items.