Separate names with a comma.
Some features disabled for guests. Register Today.
I am having the same, problem. After I home machine when first starting up, I then set go to work zero. My Z axis lowers and then my X and Y...
Thanks, found where to increase and decrease the speeds in Vcarve. It's exactly where you said it was. Up and running, thanks againfor the help.
Is the X32 different from the standard blackbox? The reason I am asking is that the standard blackbox when I connected the 2 wires from e-stop...
I read everything from the link you sent me and applied everything. I have tried different speeds but these are the ones that work best for me....
Hi Peter, I have everything up and running with a couple of adjustments I need to make. I have checked the continuity of my e-stop button and it...
Thanks Peter, I now have the grbl tab but can only get the x and y axis to off. I have tried different numbers on the $5 but can't seem to get the...
[ATTACH] [ATTACH] I just received my new Blackbox 32 and have it installed. I am running Openbuilds Xtension Limit Switch Kits on all my axis's....
Yes I did set up homing in grbl and the machine homes perfectly. When I move it to the machine position and set the the machine position to zero....
error 9
I am using grbl in V-Carve Pro as mentioned in an earlier message. I have applied all the suggestions Openbuilds has given me and nothing changes....
I have read all the articles about homing. I home, or should I say try to home, every time I turn the machine on. That is not my problem. You say...
This is getting to be my worst nightmare. I have everything working properly when it comes to homing and moving my machine around the table. My...
Hi Peter, Got the homing to work but now I am getting this error message again:
Thanks for the response but now I have a different problem. Now my home all button is not lit so I can't home my machine. It seems every time I...
Good morning, I am trying to run a job and keep getting the Error 9. I have homed my machine and gone to the work zero. As soon as I try to run a...
Refer to gnea/grbl Please read the Grbl wiki :) it explains all the settings. Use your computer to run OpenBuilds CONTROL, connect to the...
Here’s a picture of what your program just did to my new spoiler board. There’s something definitely wrong with this program or the Blackbox. As...
I have a Workbee with a bed of 760x960mm working area. I am using a Bosch 1617EVS motor. I am using V-Carve Pro for my CAD. My limit switch is...
I thought this was supposed to be a plug and play setup. I am not computer guru like you guys and don’t know what you’re talking about when when...