Separate names with a comma.
Some features disabled for guests. Register Today.
Update: So we moved the CNC table out of the corner so we can access all sides of it. That made troubleshooting significantly better. I have...
Thanks! Still at it. Ran into power access issue when shifting to better location. Resolved in the a.m. One thought: Would having the PC housed in...
Ok then after viewing the Build Video once again here is what I am starting with tomorrow morning: [ATTACH] I will start by including only...
Oops it was all in there! just bundled up tight. Looks like I got Number Sku Description 1 2558 4 conductor - 13 ft 1 2557 4 conductor - 7 ft 1...
Will do. Just unpacked the wiring that the support folks sent. Looks like they sent me 2 conductor wire based on the original LEAD 1010 limit...
So things looked good for a day or two, now the gremlins have returned! Let me paint a scenario and then ask for advice. Scenario: We took the...
Thanks! I will double check that on future cuts!
Ok Thanks, I discussed it again with the user and he felt that perhaps the center of a small letter cut out had come loose from the cut...
Hi Peter, Thanks for taking time to detail out your response. It is quite helpful. So I checked on the machine and specifically the Z...
Thanks I will begin the check there. On that note, we had random EMI a while back and we spend forever chasing them down. We added ferrite cores...
also, right after the plunge and the emergency power out I filmed the BlackBox and saw the network light flashing furiously.( see attached) Does...
Thanks for the ongoing help. I was able to get back to the machine and tighten the loose eccentric on the Y gantry. I led a orientation class...
Thanks for the help !! I tightened it all down ( X, y leadscrew stop collars, Shaft couplers ) checked the corner brackets, and was surprised...
Thanks for the feedback! I used the inches side and estimated the amount off. I guess it would be more precise to just use the mm side of the...
Very helpful. I will be back at the machine later today and see what I can find. Thanks for the trail signs!
I have been focusing mostly on Z and the machine sits in a corner so the y stop collars are a bit harder to see. I will check all stop collars and...
Would it be only on the Z axis?
So I was able to run a check on the machine and grab a few photos and measurement. I put the data in a table: [ATTACH] The photos are attached...
Hey Guys, So It started as an issue where we were getting ovals when we wanted circles. I pinged tech support and followed the punch list of...
Man, you guys are good. I think I am finally 'good to go'. Thanks and I will confirm once all is good Cheers. Richard