Separate names with a comma.
Some features disabled for guests. Register Today.
ok for the GRBL I have $30 = 24000 $31 = 0 for vfd settings are 7 = .5 11 =120 72 = 400 73 = 120 after...
ive made the changes to my settings following the above reference on the vfd settings. my issue is when turning the spindle on from openbuilds...
im trying to get mine running as well but using the Xpro V3
Ok I’ll make the adjustments and give it a shot
Ok great thank you
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
It’s a single belt 20 tooth pulley.
I’m glad is smooth on your end that confirms it’s a machine issue or setting issue. I’ll have to get the settings tomorrow at the shop.
Ok will do. I haven’t noticed a difference in the cut quality between the two so I’ll stick to the circular arcs in vcarve. Glad I’m using the...
Do you feel that it made a significant difference in the cut quality? I think that since my y axis beams are 3000mm they’re flexing way to much...
Awesome I’ll take a look at it I’m thinking if I do add them I can use some left over cbeam pieces for cross bracing since the v-wheels and...
yeah def not cheap.. im hoping to figure something else out before having to go that route
Thank you I’ll read up on this. If I can’t get the vibration/flex stopped I may be forced to move to a 15/20 mm linear rail with gear reduction...
Not on this last series of test cuts but prior to that I did try a couple with a finishing pass. It didn’t seem to help.
doesnt seem to improve the quality i ran it at 55 ipm .039" per pass 55ipm .05" per pass 55 ipm .08" per pass readjusted all the eccentrics and...
Thanks I’ll take a look at the controller and be sure it’s configured as pictured. I’m pretty sure it is but I’ll double check.
The same section on every piece I cut was the same. I ran a series of test cuts all at differ feed speeds different options in vcarve etc.
I believe the side play is fixed what I noticed was on the controller one of the lights for that motor was off so I restarted everything and it...
I’m using the Xpro 3 and the openbuilds control software. the p/p im using is the grbl mm gcode
