Separate names with a comma.
Some features disabled for guests. Register Today.
I am giving up on the interface. Haven't used the machine for a year and right back to locking up all the time. I don't get to use the machine...
Ok so today I disconnected the probe and ran two small jobs several times and no issues. I then changed the voltage jumper to 24v and ran the...
So to recap No router running(dewalt 611) No vfd All wires shielded and earth grounded at blackbox end with the exception of the interface and...
I finally got out to look at this again today. Before I did anything I cleaned the keypad with a little glass cleaner. Powered up and tried to...
ALL cables are shielded, no VFD and router isn’t running when it happens. Interface is sitting on bench untouched when it is powered up.
Firmware is the latest according to the interface. Keypad appeared clean as a whistle but I cleaned it and am now able to jog and run the probe....
Help, recently got the interface and probe. I have been able to upgrade the firmware, setup the usb stck, connect with wifi, run the probe...
The Router is getting power from a high power iot relay receptacle that I got off Amazon. Signal wire comes from gnd/pwm connector on blockbox....
@Peter Van Der Walt , Have you had a chance to look at this? Thanks
Hello Peter, I have attached the requested files, one this run it shut the router down almost as soon as it started the right side. Thanks for...
Thanks I will do that, where do I find the serial log?
I have tried twice to surface my spoilboard and each time it runs the whole surface then cleans up the left side, goes to the right side and...
I finally have my machine built but having an issue with homing the z axis. In the open builds control software I loaded the workbee 1010 config...
You clearly don’t have a good understanding of the issue, this isn’t a freeze the bearing and press in type of situation. The bearings are held...
Hello Mark I received the missing parts today, thank you. Unfortunately I have a new issue that I had to send the parts store a message about. I...
Mark, Thank you for the reply. I have watched the build video a couple more times and found that I am also missing the 4 main end plates the...
A whole 4 day weekend lost just because of poor labeling and attention to detail....sigh....
Bummer, just discovered I am missing the front X axis plate...
I am thinking about getting a workbee 1010, not sure what controller but have a question. On the xcarve controller you have to set a did switch...