Separate names with a comma.
Some features disabled for guests. Register Today.
I have an X32 Blackbox that has similar problems. I have been using it for a few months now and it was all working fine. Now my XYZ Plus probe has...
Thank you for all your help! I finally have it working as it should. I went back and re-did EVERYTHING according to the video on your site. I...
Actually Peter, that is exactly where I set Job X and Y Zero. I did not set it at the bottom left like it shows in the Control program.
Maybe if I reverse my motor wires in the Control plug. Instead of (left to right) Red, Blue, Green and Yellow I put them as Yellow, Green, Blue...
I can get it to cut the letters properly, but when the job is loaded into Openbuilds Control program it shows that everything is on the Y negative...
Sorry again Peter. In the 1st Post pictures, the camera was turned 90 degrees. The X in the lower left corner is actually in the upper left the...
Generally, when I have a problem I find out it is something quite simple that I overlooked. In the pictures, you can see that, using Aspire, I...
Will do Justintime! Thank you!
Ok, again, thank you for the help Peter. I plan on working with it again today. I know it works as I had it working prior to having to disassemble...
Yes, I inverted both the X and Y plus inverted the Homing for both. I Homed the machine then set Work Coordinates and found it still did the same...
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Ok, thank you!
Thanks Peter. Yes, my X and Y Axis’s are correct. I use the Control Program and all my Axis’s move correctly as + and - and Homes correctly, so I...
I have a Workbee 1510 using a Blackbox and Openbuild Control Software. I also use Vectric Inspire and/or VCarve 10 for my projects. I have been...
I would LOVE to get the files for this project, I use Vectric Aspire. I have been looking for them but as yet have not been able to find anything...
I would like to thank Mark and all his crew for, not only the Black Box and all the great products I have purchased from them, but also for the...
Thanks for the info Sharmstr!
Since these use a 24v power supply, will they power 4 NEMA 23 High Torque stepper motors or is this limited to the standard NEMA 23 stepper...
I purchased a Routakit SD 1000x1500 kit online and found after putting it together per the instructions, I was NOT happy with the results at all....
Joe D published a new build: I could not "tram" the spindle to the table. I found that the V Rails could not accurately be adjusted so...