Separate names with a comma.
Some features disabled for guests. Register Today.
Wow u need to sell a kit or the start of a kit I have a acro 1010 would love to d ok this with it.
Well I added a computer cooler on mine and didnt tighten the cord to the spindle down and just like that no problems Yes I did recheck the...
4ch opto-isolator module. Can I use this with the black box?
Ok thanks . Just seems over kill to me
I bought a spindle in December I get hard errors. And the software x y and z will say nuf . Home it and go back to 0 0 0 All fine then...
My cable is shielded
I'm using shielded wire and it goes up and over the drag chain 5 to 6 inches . Power and water are other side of bench. Where did u put...
I'm having the same problem it just happens out of the blue. What did u do to fix it. ?
I did that correctly I moved to wires about 6 inches away and has ran 1 hour no stop. We will see how it goes. But thanks for the help....
I grounded the shielding by the top of the the plug. The y limit switch is always on no matter what I do. Do u have pics so I can...
How do you ground the shielding?
Got a 800w spindle and got the cable that is shielded ( lol because it would cause no interference) I got it a minimum 4 inches from all other...
No problem atleast u can get it done.
I have the whole kit minus the z plates 100 shipped if u want. I used them maybe 5 hours before tearing off and starting over. Mine are off a...
Got it all going doing opposite of the diagram lol go figure.
Played with the voltage and i think i got the red lights out. Atleast for 10 mins ok 1510 normal limit switches i did like the manual about...
I am not getting it to stop on the switches either Maybe some help here need to get this rolling defective part now i have red lights...
Is there a number to call!
$20 $21 disable both
My z wont even move up now. Put my old controller back on works fine