Separate names with a comma.
Some features disabled for guests. Register Today.
So I've taken the liberty of Trying what I think should be the next experiment. [ATTACH] So I tried to set up the scenario where the Arduino is...
Ok. I appreciate your guys patience with me. What I was missing was what Peter has said. The GND has to attach to D13 to simulate a LOW output. I...
Ok, So I think I see what your trying to get me to do... I think.... But after your Explanation, I re did it but I saw that I had to wire it up...
So there is only 1 10kohm resistor to be found. My apologies if I made it sound like I had 2. I can see by the tracks on the board that the...
When I said that I expected 10k resistance in between Arduino Pin 13 and the EN legs, this was because I knew that there was a resistor in series...
So I just thought of something, I tried the other version of GRBL. And I also tried reloading GRBL to Arduino. Why is it that whenever I reload...
First, I have to tell you the Board Maker told me this in an email a couple days ago. Pretty sure this will influence the following tests. * The...
I haven't tried the LED option yet, I think I need a bit more explanation with that one. I have the things I need to complete it but not quite...
Ok. So I can answer a few of these questions right now. I am testing the EN Line from the Driver pin Leg. But I have also disconnected the...
I also tested a bit more on the Driver pins I’ve tried switching the setting $4 in GRBL to 1 and 0 Step and Dir are pulled low in Idle when set...
I know, This is a common Occurrence, but I Am Stumped. I've read all sorts of problems, but none seem to meet my criteria. My experience is...