Separate names with a comma.
Some features disabled for guests. Register Today.
Software just did an auto update. Arrow keys no longer work for jogging. Checked key bindings and they are set.
So I got home and turned on my cnc. Everything worked except for one stepper on the Y. Was walking around the cnc and put my hand on it and got a...
Can't assume any of that because I did not disconnect the fan. I turned off the entire system, not the fan, while I was doing other stuff (making...
Checked the solder points on the limit and they look good. Also rechecked all of the wiring and it looked good. After a few rounds of turning the...
Plugged the X limit back in, turned on power and now X and Z are moving but Y is not. Checked wiring before and it looked good. Did not check...
Fan is spinning. Left it off while I was doing other stuff. Turned it back on without the X limit in and it is working again. Obviously something...
Checked and $4=1 and power is seated. Since it was working last night and nothing has changed except for plugging in the X limit, I unplugged the...
Will do. Thanks for the quick reply.
I've had my Workbee running for over a year without issue using the OpenBuilds Blackbox. I've been upgrading it to the quenbe and got everything...
When I open a page on in the forum it jumps to the footer as soon as it loads. Tested in Chrome, Brave and Firefox. It only does it when I am...
Thanks Peter. I assume more than just @Batcrave and I missed the ease of just putting in the touch plate thickness.
Yeah that is the one it shows. No way to have an option to show the previous probe options? Is there going to be support for others or just the...
New Z Probe wizard is only showing an option for the Openbuilds Z Probe. I am using a plate and there is no obvious way to change it.
Thanks for the reply Peter. I swapped out my z-axis on my workbee for the CNC4NEWBIE Z so I'll double check the wiring on the Z limit.
While surfacing my new spoilboard my cnc stopped a couple of times about halfway through (motion and spindle) with no error messages displayed and...
Thanks for the quick reply Peter. I think I found the macro in these forums but I tend to run with a lot of Google tabs open so I'm not 100%. I...
Below is the macro I am using for xyz. The problem does not only happen when using the macro, it happens if I manually set xyz as well. I'll run...
Having some issues with the latest control software (v1.0.185) with the blackbox and since I am pretty new to cnc's I am not sure if it is new...
I used the stall method to set the current. It does the same thing when I have it do a run without cutting anything and push stop. It always drops...
Forgot to mention that $1=255 was already set.