Separate names with a comma.
Some features disabled for guests. Register Today.
Excellent. I really appreciate it.
No, no G53 or G28 moves
I had the same rapid movement in which it drilled down into the work piece again. I ran probably 20 jobs and then in the middle of a run, the...
@Peter Van Der Walt That was it! Colors were reversed. Thank you so much for your quick response. Mill back working with limits!
I did buy motors from you, but back in 2017. Thank you for the link. I will try and ID the pairs.
I decided to install the limit switches and the blackbox controller. However, all steppers grind and slip when I try movement in any direction....
Excellent. Thank you very much for this info. I think I will also be installing the limit switches sooner than later.
I do not have limit switches installed yet. Would that have helped?
The problem: Mill suddenly decided to dig deep into the part I was machining. Drove the bit in and I quickly killed the process. I was just...
Looking to make my own mount for a minimill and make the SL Vise to mount on it. Want to make a base similar to a 20x80 extrusion. Any...
Got it working. I had wiring incorrect. Thanks to you Bob on the how to wire the OX video.
Building a minimill with Nema 23. Using a multimeter, I found all the correct pairs of wires. Wired it up. Got green lights on two of the steppers...
Is that a Standard Z axis height? Also, looks like a 4th axis? Where did you find one small enough?
Where can I find four pin connectors (24 AWG) for the 23 stepper motors? The wire for the motors that comes with the build are way too short to...
Has anyone used a touch probe with the mini mill? If so which one?
