Separate names with a comma.
Some features disabled for guests. Register Today.
Hi, I have a similar question. In my case I use Nema 17 which has 1.68A / phase. Is it RMS or Peak? I ask because I have to set it to 1.36A RMS...
I’ve just realized, where do I connect the shield of the shielded cables (limit switch cable, stepper cable, rotary encoder cable)? I will have a...
Thank you for the fast reply. I can get 24V 5A.
Hi, this topic captured my attention because I would like to use a 24V universal power adapter for notebook to power my build. Is there something...
Is there any problem if I use 36V power source with DQ542MA (with correct current limit) and Nema 17? The motor's webpage says: 12-24VDC...
My question is about the driver’s red indicator. I have the same setup as in the video (arduino uno, grbl 1.1, DQ542MA with all terminals...
Rob, thank you for the reply.
This question is about motor selection for the V-Slot NEMA 23 Linear Actuator (Belt Driven) and about accuracy with load mouted on the plate....
Rick 2.0, thank you very much, now it is clear for me.
Hi Rick 2.0, thank you for the suggestion but I have a difficulty to visualize your solution. Do you mean to replace the original Iddler Pulley...
Does the ENBL input enable/disable just the communication (PUL, DIR) or it cuts off the power of the motor? If the driver is disabled, does it...
Hello Rick 2.0, thank you for the reply. I have not considered the dual shaft stepper mount because, I think, I should be watching the plate/load...
Hello, what would be the best way to mount a rotary encoder on the linear actuator? I have two reasons to do it: To know the exact position of...
Thank you for the reply. I suppose, it must be quite difficult to predict all the properties of the linear actuator in a specific use-case...
Hello builders! I wold like to use this build (1500mm with NEMA 23) in a research lab. I have no experience with linear actuators, so could you...
