Separate names with a comma.
Some features disabled for guests. Register Today.
So all you should need to do is perform the Z probe operation, remove the probe, goto zero and make sure that the bit is flush with the work...
I understand you are using a zprobe. However, the probe sits above the table or workpiece. The probe senses or thinks zero is at some point...
Zero your axis especially the Z, Use the goto zero button. Check the distance between the work piece and the bit. There should be little or no...
Did the USB driver get removed or perhaps corrupted?
I would still check to make sure that your touch probe is producing the right results because I use .2 all the time and it works fine. Have you...
Do you have your clearance setting (Z1) high enough? If so, have you checked that after zeroing the Z axis that it goes where it should? In...
I guess I would make sure that the home (starting) position in your g-code matches the physical position. If your program assumes the carriage is...
Thanks Peter. However, the screw was turning the wrong direction. It turns out that one of the coil wires had come loose. The collars were...
This is in the Y axis
I upgraded my open builds to use a lead screw drive train, using the black box. When I change directions using the jog, one of the motors drives...
Thank you. Getting ready to try it
Sort of a newbie here. I am wondering if there are different parameters for the hight torque motors vs the standard steppers. My naive mind...
You are the man. Great first project. Thanks for the info. I think I need to get one of those spindle things.
Nice build Aaron. I was wondering if you could share info on the spindle that you purchased and how it is working for you. Again great job.
I am in the process of going to ball screw with a 1500 x 1500 platform. I used a belt system for X and Y. I was not impressed with its...
I have been building my Workbee 1510 plus. I finally got everything together. I actually tried driving all three axis before and all went well....
