Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you for the video! It was a life saver! Worked like magic! I think it will be beneficial if the guys from the openbuilds team need to...
Thank you so much for taking the time to answer my question. I needed every single tip. Your information is very clear and easy to follow. After...
Greetings all, With all the help I have received I was finally able to finished assembling my Workbee, I have not test it with an actual cut yet....
[MEDIA]Hi! With all the help I received I was finally able to finished assembling my Workbee, I have not test it with an actual cut yet. I did...
It took me a second to figure it out and I wouldn't have done it without the open build community help! *This's is what the open source/open...
Thanks for your support! I follow your suggestion and wire the Nano directly to the driver without the screw shield and it did work flawlessly....
Thanks for taking the time to response. I was checking the voltage from the shield and Nano. I triple checked the wires and didn't find any...
For some reason I can't get any voltage from the screw shield. The 5v on the shield has voltage but the ground point not grounded unless I touch...
I have checked the Nanos with a scope and they seem fine. The nano settings are identical to the uno settings. I have order 10 additional Nanos to...
It could be the settings but I doubt it the wiring. The reason I say this because I can just swap the Nano without messing with any wire and still...
Yes. I tried to swap it and it does work when I do. I have a scope and will check them tomorrow. I tested another Nano, with this one I can run...
I did program both Uno and Nano. The EstlCam recognized them as if they were programmed and show them when I try to tluse the controller, however...
After all your help I was finally able to wire the step drivers. I was trying to do a run test to make sure everything went well. I programmed the...
Thanks! I got it this time! I was thinking that I need to connect the + pins into the arduino the whole time. Thanks for your time, patient and...
Thanks for taking the time to check my setup. However, this is were I get confused "wire all + connections together to +5" My step driver don't...
Can you please do me a favor and check if I get this right?
I'm not quite sure what are you referring to. I'm planning on using DM542T drivers. Can you please tell me which pin? Thanks!
Are you referring to the ENA+ (+5v)?
Thanks for the quick response! I can see fuses and capacitors?
Thanks! Looking forward the completed version!