Separate names with a comma.
Some features disabled for guests. Register Today.
Can you post a picture of your wiring, there are also settings inside the VFD that need to be set.
Does anyone know if you can use CLS or Servos with the OX BB?
Here you go.
Is there a plan to add a half function to control to do edge finding of material stock?
Keep in mind there are a few Chinese VFD boxes out there and some changes may be needed.
The build is rather straight forward. On the X, Y, and Z axis add the MGN-12 rails by drill and tapping holes 25mm spacing on center. you will...
So I have used 3 sets of the SN04 sensors and they run great for a week or two then they go up in flames for no reason.
Had black and blue switch and had to set $5=1
I installed my sn04 sensors and they light up when metal gets near them however it doesn't trip the limit even though the sensor light comes on....
Do pnp sensors also work? I have some in my shop?
It was a 2 wire sensor, I just bought some 3 wire ones.
I set my jumper to 24v and connected the wires to v+ and gnd and put a 2.2k resistor between gnd and sig and I keep cooking my sensor, am I doing...
A lathe would be great too.
OberSchutze published a new build: I added the steel to create a less flexible milling surface to make heavier cuts in aluminum. I can also do...
Would it be possible in a future revision to add a couple of more jumpers to allow full digital control of a HY style VFD though the tookhead...
I wrote up a little how to guide on how I resolved this issue. Hopefully it can help others out with similar issues. OpenBuilds BlackBox to...
It is a klugy solution but I put the jumper on the coolant setting and use m8 to turn the DCM to FOR connection closed. Then use m3 sxxxx for...
I added a estop switch between DCM and FOR to reset it. Am I able to use that relay to do the same thing?
Bit of an update. I got the speed portion to work correctly now, removed the relay function jumper on the BB. Only issue I have now is when I type...
Right I set m3 s12000 and it still goes to 24000, then when I set m5 it idles at 6000 instead of turning off.
