Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks Gary, that worked. :)
Hi Gary, I'm hoping you can help me. I have a workbee (lead screw) with XproV3 and have been using Estlcam, I used the settings you showed and...
This is great, thanks! A dumb question, is the feed rate inches/minute? I'm UK based. Cheers
I purchased my workbee from Ooznest in the UK and this may help, which is from the assembly manual: Run any piece of C-Beam extrusion in between...
That's funny, my laptop is about 10 years old running windows 10. I'll have look at what you suggested. Thanks :thumbsup:
Thanks Gary. I am controlling Estlcam with my laptop, not sure what a SSR or contactor is, sorry. I will wait for the Makita to arrive and follow...
Hi Gary, thanks for your reply. I'm using the latest stable version 11.029. One thing I did notice was occasionally when I turned the router on...
I'm using the Estlcam controller and for some reason half way through a routing run it crashes with the following error: USB ERROR: SENDING FAILED...
I managed to set the limit switches okay but did have the same problem when trying to program the controller, Estlcam crashes so I installed V10...
Great thanks guys, I'll give it a go. Much appreciated.
Hi Kelvin, I'm going through the exact same steps as you, Workbee, Xpro and Estlcam and also seeking advice, you beat me to it posting the same...
Hello, new member here seeking some help/advice. I need to produce a single 35 diameter counter bored hole in a piece of 25mm thick plywood, my...