Separate names with a comma.
Some features disabled for guests. Register Today.
But what will LinuxCNC think of it? Also, how'd you pull off that trick? It's been a number of months since I looked at it, but I thought they'd...
Entirely possible, but Mach3 is also very temperamental when it comes to what hardware it's running on. I had a lot of trouble with random stops...
It also depends on where your system is picking up the EMI. Mine was coming in (as I'm sure I mentioned a time or three somewhere in this thread)...
One other question (completely unrelated to the spoilboard/worktop issue - sorry)... Is that vacuum hose running to a shopvac, or do you have a...
Thanks for posting this. I'm in the middle of plotting out a design for a new bench for my LEAD (designed to roll into place over a big metal box...
Sorry I'm a little late in replying to this, but are you, by any chance, using the LED ring on your spindle? I discovered that mine, being wrapped...
I was working on a 18ft replacement panel for a garage door, and was really dreading the idea of scrubbing it (or of dragging it somewhere it...
I've still never seen amine blush, although I did use West Systems for a large coating project a couple months back (I've still got some left, and...
Of course, it also means it'll be less penetrating in the directions I do want it to be. :p The demold time would be great, but I don't think I...
That's sort of the impression I'd gotten. Especially the "toxic" part. Ok, I guess I can see the advantage there.. but Is speed anything more...
Which isn't available, at least in any official capacity. Very fast. And that. But given the lack of a thinner, the fact that I'm at least a...
A bit of a long shot, but is there any chance a post-carve coat of spray paint would both stay on the surface and seal against bleeding? (also,...
I've thought about trying to spray something on it (I've seen recommendations elsewhere to use a spray coat of lacquer or shellac), but I think...
So... I tried both of the current contenders on MDF - Peter & Rob's suggestion of a brushed on coat (center), and Giarc's idea of pre-sealing...
Update: Most of the day got sucked down into a big constructiony project, so I just managed to start the tests. I'm going to be stuck waiting a...
Now that's something that (despite @ljvb's suggestion of pre-treating with sanding sealer) I hadn't even considered. I don't usually think of...
One other thing that hadn't occurred to me before... I've still got a couple cans of CPES ("Clear Penetrating Epoxy Sealer" - read: a whole...
I've tried a heat gun in the past (well, on epoxy, not Alumilite), but always ran into trouble finding the sweet spot. If I got rid of the bubbles...
Sadly, no. : "There is not a chemical available for purchase to make Alumilite Resin a thinner viscosity. We do have thinner viscosity resins than...
I thought about trying that... but if you take a look at the design, a lot of those lines are maybe .025" wide by not much deeper, and I think the...