Separate names with a comma.
Some features disabled for guests. Register Today.
Well I reinstalled grbl 1.1 on ardunio Then after a few trys in Openbuilds control I sat back and thought... Taking in whats on the screen, I...
Ok x axis trying to move 250mm moves 150.5mm change grbl settings to 66.445 and it does NOTHING still 150.5mm what do...
David thanks once again Got a bit of figuring out to do to tailor grbl steps, but I feel I have some programs I can put some faith in that will...
I kinda knew it as something to do with the steps had the same problem with a laser burner , would just make ovals and not circles well back to...
Hello everyone I have ardunio uno using grbl panel running a c beam type cnc I was trying out openbuilds g code generator Glad to see that the...
I will try openbuilds generator and the foam idea...for when it goes down and tears across the board and thanks for the advice on everything else...
Thank you very much Knew it was something simple I remember reading the G1 command somewhere It's like learning another language, gotta do...
Machine is up and running Trying to wrap my head around gcode trying a simple box x,y,z axis going through the steps fine setting the feed rate...
Oops my bad... power supply is 24 volt running nema 23 motors coupled with arduino mini nano that should all run well together...right? next week...
From getting some advice from the forum, Motors are fine but trying to run nema 23 with a 12 volt power and arduino drivers are most likely the...
Screw pitch is 8mm believe the nema 23 are 179oz if that sounds right the drivers are a4988 on ardino uno shield board My REAL setup is a arduino...
Have a cnc machine built from scratch looks like a c-beam jr. Put it away for a while ( Frustation ) now I am back at it... Everything is going...
Giarc I believe you were right. I changed to mm and also changed my drivers to 1/16 and the machine slowed way down I really am finding my way...
Jogging step by step each axis moves about an inch but when I try to test a nc file everything goes max z up, max y out and max x right looking...
Thanks for pointing at gnea/grbl just didn't know where to look for a manual or any advice I built this and understand the workings now I have to...
If someone could toss a bone and tell me what I can do I have a c-beam type of machine using Grbl Panel arduino uno M335 drivers as soon as I try...
Very new to cnc and building one for that matter Started with a laser engraver and am hooked I want to do more I am building a c-beam type of...
Yeah Glenn I seen after I sent you a reply that your post was back in 2016 I started woodcarving as a hobby and decided to try to produce more...
Hi Glenn I am very new to this and am building a c beam machine and just ran into this problem I see Openbuilds sell a 540mm screw which is the...
