Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks Peter! Appreciate the tip on searching with grbl
I was wondering if anybody has any experience setting up GWizard Editor with the Blackbox for simulation (post file, etc) who's willing to share...
First off - I want to thank everybody who offered advice and recommendations - this is an awesome forum and I really appreciate all the...
Thanks for the quick reply Andreas - the motor is turning - I checked and rechecked the lock collars and they're all very tight. Do you know of...
Hey Peter, Sorry it took so long for me to get back on the forum - injured my back and been out of the shop for a while. Got back in the other...
OK...will give that a shot too...thanks!
Thanks Andreas - I'll try that too. Don't think it's heat related as the issue happens almost immediately (on the first two letters of the "Hello...
Thanks Peter - will try that and get back to the thread - was thinking the same thing, but thought I'd see issues with jog as well if the wiring...
Sorry for the delay - life intervened :-) I checked the pulleys and all is good. I'm thinking it's either the motor or the driver as it only...
Thanks Andreas - I'll put a mark on the lead screw/pulleys and see if that's the problem. :-)
UPDATE: Ran the calibration wizard for the Z-Axis using a marking knife on the aluminum and my digital caliper...accurate at 50mm of travel to...
Will run calibration today...thanks!
Hi Alex, I'm using the BlackBox controller and my grbl settings are at 119.100 for x, y and z. I haven't yet run the calibration wizard - I'll...
I'm using the BlackBox and the $102 setting is 199.100 (same for x and y axes). I'll run the calibration wizard today and see what happens....
Just built the Sphinx 55 and all is working. However, when I run the "Hello World" file as a test, the Z axis is driving down about 4mm on each...