Separate names with a comma.
Some features disabled for guests. Register Today.
David, I got one from CraftyCNC off of EBay. I have not been able to get it working with Control other than as a simple probe. I have a BB 4X. I...
If your router is a Makita, the “EMI shielding bulge” is actually just a plastic clip with anti-theft RFID tag inside. I took mine off to move it...
Keith, For a Bowden tube design, where would the extruder go? It look like there is something attached just below the top handle.
I have been using masking tape and superglue and have been impressed at how well it holds on my C-Beam Machine even during crashes. My only hold...
I raised my x axis by 20 mm with the stock hw by putting the bottoms of the vertical 20x60s on top of the rear bottom crossbar instead of behind...
Thanks. Stan
I have an Interface on order, but I have a V2.3 Black box. Is it Ok to provide a separate 5V to the Interface and only run tx, rx, and Gnd to the...
Have you tried moving the battery towards the side opposite the motor to balance the weight distribution?. A fish or postal scale would help you...
This is just my 2cents, but I had similar issues and after lots of searching and tightening, I found that my spoiler board was shifting under load...
On my Makita, the “ferrite” was just plastic with a security strip inside. A flat blade screwdriver pushed into the clips will open it up. I...
I can’t find any info on what lubricant to use for the new thrust bearings in the parts store. Dry lubricant? Grease? I flipped the bearing...
One thing to check that I ran into was on an old CNC Shark converted to Grbl, I had a consistent offset like yours (along with other Shark related...
I was able to square the 250mm sections by sanding the ends on a piece of 220 grit sandpaper on a flat surface. You can check squareness by...
[ATTACH] [ATTACH] I am building my C-beam machine and I came up with a variation that increases the z height by 20mm with the stock components. I...
