Separate names with a comma.
Some features disabled for guests. Register Today.
From unresolved error now to broken z limit switche. Could someone show me how to use the Workbee cnc router without the limit switches?
Thank you for your reply I increased pull off to 25mm. Nothing changed.
No it is the same error I have been getting all this while. This same setup works perfectly prior to relocating the Workbee. What shall I do now?
i Ensured the limit switches wiring is in the above order. And I continue to get this error as the z axis moves passed the limit swithch. The...
@Alex Chambers Please is there a way to manually home my cnc router? This will be a good alternative to my none functioning limit switches
@Peter Van Der Walt ,@Alex Chambers please can you take a look for me now?
[14:50:42] [ 3D Viewer ] WebGL Support found! success: this application...
Thank you for your message. I will check out how to do that and post accordingly. UOTE="Alex Chambers, post: 88830, member: 123072"]Hi...
Thank you @Alex Chambers I have wired all switches in similar order. But Will check to make sure.
Thank you for your response. I was looking for away to run the cnc router without the limit switches. Invert Y stepper on grbl settings resolved this.
Please if the limit switches will not work, How do I setup work with out those? I have tried several times but the y axis keeps straying off work.
Thank you for your observation. What shall I set the probe pin to please?
Thank you for your response. I have changed the homing debounce rate to 250 and the wiring moved as you suggested. Upon homing afterwards, thaz...
Thank you for response. I have changed the homing debounce to 250 and moved the wire as advised. Upon homing, the z axis moved past the switch...
Thank you for your reply. I uploaded the requested file
@Skip S. Please share your resolve. I cannot route any job because of same issue
HI, thank you for your post. I have been challenged by the same issue for up to 4 days after moving my workbee to a new location. Could please...
Thank you for your help. I have resolved using the settings link
Thank you for the info