Separate names with a comma.
Some features disabled for guests. Register Today.
...and am still having problems. Here is my setup: 110v 1.5kw huanyang VFD (model HY01D511B) 800w 110v Chinese spindle Blackbox motion control...
Hello all and thanks for taking the time to read this thread. I just built a Work Bee CNC router and having an issue with getting the VFD going....
[IMG] Please help I’ve been through two replacements of these VFDs and they all keep frying after my wiring is like it says in the manual. I took...
Before ordering my VFD, I did not do a search on the GT version and this forum... LESSON LEARNED. I've since read the posts and understand the...
...my own design cnc. I recently bought a 2.2 KW spindle and Huanyang VFD set via ebay that I want to run in combination with a CNC xPRO V4...
Can anyone help with the settings on the Huanyang VFD, not sure what the setting should be for my Openbuilds 1515 Blackbox and the Huanyang VFD...
I'm pulling my hair out and need Help. My Huanyang VFD HY01D511B won't spin past 200Hz. It seems to make no difference if I control with my...
Huanyang Chinese Spindle, VFD settings and manual here! This is a link to a thread on CNCZone.com with questions on the Chinese Spindle & VFD...
Huanyang VFD 220v 2.2KW Water Cooled Spindle I have been over the settings and I just can seem to find the one for this. The spindle will only...
Has anyone used a Huanyang GT series VFD with the Blackbox control? I am trying to figure out how to set up the VFD to accept the 0-10v / PWM /...
Hi, I've inherited a OpenBuillds platemaker without full information and it's got a spindle I was hoping someone might recognise it, though...
Just wanted to leave a note to an issue I had with a Huanyang Spindle and VFD EMI Problem on my modded Sphinx 1010. Backstory: I was running an...
I installed a 2.2kw 220v 1single phase spindle with matching inverter on my Workbee 1510. Wired to a 220v 30 amp breaker. Programmed the inverter...
...on the end of a cable shield are a no-go, however inside the huanyang vfd connection area its all plastic, so nowhere to clamp the shield...
After a series of frustrations, the 110V Huanyang VFD (HY01D511B) driving my 1.5kW spindle finally let the smoke out (under at least partially...
I have been running my Chine's VFD/spindle since 2021. Today at the end of my last cut the spindle didn't fully stop but continued at a low RPM...
I am setting up a Mophorn 220v 4KW air cooled spindle with an A2-8040 VFD Have read through the Openbuilds documentation for setting up the 0-10v...
Hello, do you have a wire diagram from the black box to a huanyang vfd. I cannot find a diagram to match the output. Also the 0-10v line does go...
I have a Huanyang 2.2kW Air Cooled Spindle Model #: HY02D211B Running it with the OpenBuilds Blackbox X32 I have set everything per the...
My old router burnt out and I decided to upgrade to a water-cooled spindle with a VFD. I purchased a Huanyang Water Cooled Spindle 2.2kW 110v VFD...