Separate names with a comma.
Some features disabled for guests. Register Today.
No problem atleast u can get it done.
I have the whole kit minus the z plates
100 shipped if u want. I used them maybe 5 hours before tearing off and starting over. Mine are off a...
Got it all going doing opposite of the diagram lol go figure.
Played with the voltage and i think i got the red lights out. Atleast for 10 mins ok 1510 normal limit switches i did like the manual about...
I am not getting it to stop on the switches either
Maybe some help here need to get this rolling defective part now i have red lights...
Is there a number to call!
$21 disable both
My z wont even move up now. Put my old controller back on works fine
Full power and low power the same thing
Turn off power and my axis work correctly then 30 seconds same thing
Ok got new box and after turning on my black box axises lock then i move just a little and i have red lights on all axis but z something new.
Detecting a change is unpluging andpluging in usb
Also the flash failed also. As u can see
every step worked
4 hours of searching forums to find out if anything else. I figured would work ouf of the box put the old controller back on so i could cut...
I think i did all that but will do again 4 hours last night
Here light that stays on
When u plug usb in there is a light at top on by stepper and the usb. on the side with reset comes on for a second.
Usb and power only hooked up
Ill get pic of com ports for u
Here is what is shows