Separate names with a comma.
Some features disabled for guests. Register Today.
that's what happened to mine
I updated java and uninstalled all old versions thought I was good till I went to the java site and ran a check on...
just a little note not sure if it will help but i have been using universal gcode sender with out problem went to use it today and when i tried to...
Not bad for first try need better bits but turned out pretty good
got some small tweeks but working pretty good
I was using 12v 350w that came with kit from swm3d i ordered a atx 600w from open builds to have as back up that one is working good at...
After thunking on it all night and reading responses
i swapped out power supply and holy :brb: It worked ran program and all ,moved...
I thought so to but it was set at 50 so turned all way up nothing turned all way down didn't make a difference where current is set
ok got it to work somewhat when you go into maker cam you have to change it to cm :banghead:
works better but the movement is sketchy it moves...
Thanks for all the advise from everyone I new I was going to have learning curve but thought I could get threw it didn't expect it was going to be...
well I got it to move with out sounding like wood pecker it moves steady but sounds like the steppers rev up have to work on it some more
started going threw things tonight
made sure jumpers where on 1 and 2 good there
1 i unhooked y motors to count them out im just trying to...
ill go threw it again and double check everything again
i have gone thre it twuce but i could have missed something
I have cranked the current already doesnt make difference
I am powering board from power supply only have the + - hooked to board I have the power supply plugged into power strip tried plugging power...
Should of said x moved fine but still was not close to moving the right amount moving 2 times as much so I droped step/mm by 1/2 and started to...
Thanks for the help Johny
My drivers are not getting that warm at all
I tried your settings and still chattered set 100 at 53.33333
Its that loud using max rate of 7500
and acceleration of 100
ill try your rates and see what happens thanks
Serge thanks for all the info and help
this first video is of the original setting from grbl 3.6.1...
Well tried your settings and did not work do well
its a stock op ox with g3 belts and 20 tooth pulleys
as for mass setting changer...
Im using grbl
i have tried that i get 26.667 put tgat in and when i jog the machine the steppers chatter when they move ill try to post video tonight