Separate names with a comma.
Some features disabled for guests. Register Today.
Very nice studio desk.
Getting confused again.
I was poking Kyo on YT about if they posted this on the forum yet. It's a great build, but I don't know what those electronics cost yet.
You can finish drawing the triangle on that face and extrude cut it. You can also use fillet on that top corner and choose two distances for...
Jeff's a doer. Good job Jeff.
I don't have this combination of equipment and software so I can't give you a step by step, but it's all basically the same. Vcarve is your...
Short answer is yes. I don't use grbl so I'm not familiar with its quirks.
Typically to continue a job where it left off I would rehome, copy and...
@LarsTveito is using one of these boards.
Check his thread to verify...
Since the arduino is a usb device then you are right...you will not be able to use it with the LPT. Here is a discussion about this topic....
There are a number of iterations of those. Which do you have?
Is this the board?
Geekcreit® 5 Axis CNC Breakout Interface Board For Stepper Driver Mach3 With US - US$7.18 - Banggood Mobile
Do you have the interface board plugged in to the 24v supply too?
You want to get the machine jogging around first before you throw any code at it...
Hi Jack. Welcome.
Are you able to jog the machine around?
Is your gcode less than 500 lines?
Are there drivers associated with that usb to lpt...
Can you counterweight it?
What do you mean by run properly?
The torque differences I've seen between 6.8 and 3 have been negligible to a router build. Same for the...
Or a wooden board until they can mill a case.
Welcome to the forums. Is this going to be a moving bed build?
I think this is go is going to depend on screw pitch, motor size, and torque curve data Gary.
I was gonna go there too. Went to bed instead. :)
Here's another good one:
AMPS Phase vs. AMPS Peak | Lin Engineering